AXL F SSDO8/3 1F
6
PHOENIX CONTACT
106888_en_01
4
Assembly, removal, and electrical installation........................................................................... 29
4.1
Assembly and removal ........................................................................................ 29
4.1.1
Unpacking the module ......................................................................... 29
4.1.2
Preparation and assembly ................................................................... 29
4.1.3
Setting the DIP switch .......................................................................... 30
4.1.4
Mounting and removing the module ..................................................... 31
4.2
Electrical installation ............................................................................................ 33
4.2.1
Electrical installation of the Axioline F station ....................................... 33
4.2.2
Electrical installation of the module ...................................................... 33
5
Parameterization of the module ................................................................................................ 35
5.1
Parameterization in a SafetyBridge system ......................................................... 35
5.2
Parameterization of the safe outputs ................................................................... 36
5.3
Behavior of the outputs in the event of enabled switch-off delay for
stop category 1 .................................................................................................... 37
6
Connection examples for safe outputs...................................................................................... 39
6.1
Explanation of the examples................................................................................ 39
6.2
Notes on the protective circuit of external relays/contactors
(freewheeling circuit) .......................................................................................... 41
6.3
Measures to achieve a specific safety integrity.................................................... 41
6.4
Single-channel assignment of safe outputs ......................................................... 43
6.5
Two-channel assignment of safe outputs ............................................................ 45
7
Startup and validation ............................................................................................................... 49
7.1
Initial startup ........................................................................................................ 49
7.1.1
Startup mode ....................................................................................... 50
7.2
Restart after replacing a module .......................................................................... 51
7.2.1
Replacing a module ............................................................................. 51
7.2.2
Restart ................................................................................................. 51
7.3
Validation............................................................................................................. 51
8
Errors: messages and removal ................................................................................................. 53
8.1
Displaying and reading errors .............................................................................. 53
8.2
Acknowledging an error....................................................................................... 53
8.3
Module replacement following an error................................................................ 53
8.4
Note about the error codes .................................................................................. 54
8.5
Error codes .......................................................................................................... 55
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
