Phobos MAGICAR M870AS, User Manual

Page: 60 / 88

60
EN EN EN EN
5.7. Battery saving function
When the battery is almost empty and ready to be replaced, the battery icon will flash and
Battery Save Mode will be in operation.
Battery saving mode operation:
The remote will only receive the confirmation signals for button I
operations. The other buttons will still be in function, but they will
not receive confirmation signals back from the vehicle.
5.8. Door open indicating function (optional)
When disarmed, the hazard lights will flash to indicate that the door is opened. (See
programming menu 1-06).
5.9. Open trunk indicating function (optional)
When disarmed, the hazard lights will flash to indicate that the trunk is open. (See
programming menu 1-08).
5.10. Time information backup
This saves time information (start-up reservation time and alarm time) in case the power has
not been supplied to remote (at a time of replacing batteries). If the power is supplied again,
users do not have to re-adjust the time information.
6. Valet mode (without remote)
You can set the alarm system into valet mode even without the remote control (in case of a
lost or damaged remote). You can enter valet mode without using a PIN code or with PIN
code (see programming menu 1-10). By using PIN you will decrease the risk of unauthorized
valet mode access.
6.1. Entering valet mode without PIN code.
Open the door with a key.
Alarm will be triggered. Wait for 30 seconds until siren is mute.
Within 3 seconds repeat 3 of the following steps:
1. Turn the key to the “Ignition On” position. When the ignition
is on, the lights on the dashboard will be turned on. In most
vehicles this position is two “clicks” forward from the “Off”
position.
2. Turn the ignition off. The lights on the dashboard should be
turned off.
3. Steps 1 and 2 must be repeated for a total of three times within three seconds.
Once this has been done, the alarm will turn off and valet mode will be active.
6.2. Entering valet mode with PIN code.
Steps for setting up a PIN code are described on page 61. Default factory code is 11.
1. Alarm is armed.
2. By opening the door alarm will be triggered. Siren will go off.
3. Within 3 seconds turn the ignition on/off three times.
4. Lights will flash once.
5. Push the button on RPS as many times, as your first number is. Intervals in-between
the pushes must not be longer than 1.5 sec.
6. Lights will flash once.
7. Push the button on RPS as many times, as your second number is.
8. Lights will flash twice and siren will be turned off.
Valet mode is activated.