Phobos MAGICAR M870AS, User Manual

Page: 61 / 88

61
EN EN EN EN EN EN EN EN
6.3. Valet mode deactivation.
You can deactivate valet mode only by using the remote control:
Push buttons I and III shortly at the same time.
Siren will beep once and lights will flash twice.
7. Programming
7.1. Remote control programming.
System memory is designed for 3 remote controls. We recommend programming the
remote controls at professional installation service stations.
1. Alarm is disarmed.
2. Within 3 seconds turn the ignition on/off three times. The lights will flash once. Now you
are in valet/programming mode.
3.
Within 6 seconds press button l on your remote control shortly. Lights will flash once to
confirm programming
.
4. The same way as in step 2, set the remaining remote controls. Lights will flash once to
confirm each remote. System will automatically exit the programming mode after the third
remote is set up or after 6 sec. time, which will be signaled by two flashes of the lights.
Note !!!
When programming new remote controls, old ones will be automatically erased. If you have
only one remote, it is not necessary to program it 3 times.
In case of losing or damaging your remote control...
If the alarm is armed and you have lost or damaged your remote, you can still open and
disarm the car by entering a four-digit code via RPS
.
7.2. Setup of PIN code
PIN code is set as a factory default code (11). PIN code must be inserted to enter Valet mode
after turning key on/off 3 times, if you already selected “PIN code” from optional table.
Procedures of changing PIN code from the factory default code 11 to owner’s own code
1. System is disarmed.
2. Maintain the conditions of trunk opened and door opened.
3. Turn the ignition key on/off 3 times. Lights will flash once. Siren will make a long beep.
4. Push the button on RPS as many times, as your first number (1-9) is. Intervals in-
between the pushes must not be longer than 1.5 sec.
5. Siren beeps once. Lights will flash once.
6. Push the button on RPS as many times, as your second number (1-9) is.
7. Siren beeps twice. Lights will flash twice.
8. Press button IV on remote for authentication. Siren beeps 3 times and lights will flash
three times.
Set-up completed.