Phobos MAGICAR M870AS, User Manual

Page: 58 / 88

58
EN EN EN EN
4.19. TURBO mode
This function must be enabled in programming menu 1-01. If turbo mode is enabled, after
tightening up the handbrake, turning the ignition off and door closed,
the engine will remain running for the preset time.
Press buttons III and IV shortly.
While the engine running in Turbo mode, display will show a
flashing icon and the remaining time of engine running.
You will turn the function off again by pressing buttons III and IV
shortly.
You can turn turbo off (if the engine is running) by pressing button ll for more than 2 sec. If
you turn turbo off with the engine running, you will turn the engine off as well.
If the door is opened with the turbo mode active, the engine will shut down within 20 sec.
Extending the turbo time:
a) If you need to extend time of the engine running while in the turbo mode, keep button
I pressed for more than 2 sec.( the engine must be running)
b) Display will flash „Turbo Again“ and the engine will be running again for the preset
time.
Turbo mode is designed for vehicles with turbo chargers. When working hard, the turbo
housing will get very hot, but allowing the vehicle to idle for a few minutes will cycle more oil
through the turbo, while it is cooling down.
Warning
!
Since engine is running without a key with this turbo mode, the driver should make sure that the
vehicle’s gear is set in neutral.
4.20. RPS (Remote Paging System)
Using MAGICAR M870AS it is possible to call the owner of the car
to the vehicle, if the car is armed and the RPS mode is on.
If you knock quickly two times in row on the window, where the RPS
is fixed, hard enough for LED light to remain lit red for a few
seconds, the owner’s remote will start beeping and vibrating (if within the range) and will
display icon as shown. The owner will be thus made known that someone is there next to his
car and is calling him. By knocking on RPS the alarm will not go off. Remote will be beeping
at 6 seconds intervals, until you press any button. You can adjust sensitivity of RPS at 3
levels on the reverse-side of RPS.
Buttons (III + IV)