The sealing ring
may be stuck under
the edge of the
distribution disk.
Check if the sealing ring is stuck
under the edge of the distribution
disk. If it is, pull it out from under the
distribution disk carefully.
Water drops on the
worktop may be
the result of placing
the water reservoir
or removing used
coffee pods.
Check if the water drops on the
worktop are not the result of placing
or removing the water reservoir or
removing used coffee pods. Make
sure that you do not remove the water
reservoir when the coffee machine
is heating up. This may cause water
that normally ends up in the water
reservoir to leak out of the machine.
In all other cases, contact the
Philips Consumer Care Center
in your country.
The machine has
been stored in a
room that was not
frost-free.
Contact the Philips Consumer Care.
Center in your country.
The appliance
switches off
automatically after
5 minutes.
Appliances with this logo
,
switch off automatically after 5
minutes of inactivity to save energy.
Flush before first use
Flush the machine before first use. After the flushing cycle (which only takes
approx. 2 minutes), the machine is ready for brewing coffee.
Intensity Select (HD6556, HD6555, HD6554)
It is possible to brew even shorter stronger cups of coffee by double pressing the
1-cup or 2-cup button.
Special coffees
To brew a special coffee, place a cappuccino pod, a hot chocolate pod or
another special coffee pod in the 2-cup pod holder and press the 1-cup button.
2x descaling, 2x rinsing
Descale the machine at least every 3 months. Use liquid SENSEO® descaler only. The
descaling procedure consists of two descaling cycles and two flushing cycles. Each
cycle lasts 5 minutes. Fill a jug with 1 liter of water, pour one half of the bottle in the jug
and then pour the descaling mixture in the water reservoir. Press the 2-cup button
several times until all descaling mixture is used up. You have to use 1 jug of descaling
mixture for each descaling cycle. Use the 1-cup pod holder with a used pod or the
thin descaling filter during the first descaling cycle and use the 2-cup pod holder with
a used pod or the thick descaling filter during the second descaling cycle. Fill the
water reservoir with fresh water and press the 2-cup button several times until the
water reservoir is empty. Repeat this for the second flushing cycle. Do not interrupt
the descaling cycles and do not switch off the machine before you have performed
the two flushing cycles. Throw used pods or descaling filters away after use. For more
information on why it is important to descale, when to descale and how to descale or
which descaler to use, visit our website at www.philips.com/descale-senseo.
Automatic shut-off.
The appliance switches off automatically after 30 minutes. Appliances with this
logo
, switch off automatically after 5 minutes of inactivity to save energy.
Deutsch
Einführung
Herzlichen Glückwunsch zu Ihrem Kauf und willkommen bei Philips! Um die
Unterstützung von Philips optimal nutzen zu können, sollten Sie Ihr Produkt unter
www.philips.com/welcome
registrieren. Diese neue SENSEO® Kaffeemaschine
(HD6554, HD6555, HD6556) bietet Ihnen eine größere Vielfalt dank Intensitätsauswahl.
Neben dem langen, weichen SENSEO® Kaffee können Sie einen starken, kleineren
SENSEO® Kaffee zubereiten, indem Sie die Taste einfach zweimal drücken.
Sauberes kaltes Wasser
Verwenden Sie täglich sauberes kaltes Wasser. War die Maschine über 1 Tag nicht
in Gebrauch, lassen Sie vor dem nächsten Aufbrühen sauberes kaltes Wasser
durchlaufen. Um die Maschine durchzuspülen, füllen Sie den Wassertank mit
sauberem kaltem Wasser, stellen Sie eine Schüssel oder zwei Tassen unter den
Auslauf, und drücken Sie mehrmals die 2-Tassen- Taste, damit heißes Wasser
durchläuft, bis der Wassertank leer ist.
Frische Kaffeepads
Verwenden Sie die speziell für Ihre SENSEO® Kaffeemaschine entwickelten
SENSEO® Kaffeepads für ein weiches, volles Aroma. SENSEO®-Kaffeepads bleiben
länger frisch, wenn Sie sie in einem verschließbaren Behälter aufbewahren.
Ein sauberes Gerät
Reinigen und entkalken Sie die Philips SENSEO® Kaffeemaschine alle 3 Monate.
Weitere Informationen über die Wichtigkeit des Entkalkens, Anweisungen
zum Entkalken oder den richtigen Entkalker finden Sie auf unserer Website
www.philips.com/descale-senseo.
Wichtige Sicherheitsinformationen
Lesen Sie diese Bedienungsanleitung vor dem Gebrauch der Maschine
aufmerksam durch, und bewahren Sie sie für eine spätere Verwendung auf.
Problem
Possible cause
Solution
My coffee cup
overflows with
cold coffee
You did not flush the
machine before first
use.
Always flush the machine before
first use.
The indicator light
flashes slowly.
The machine is
heating up.
If this takes longer than 2 minutes,
contact the Philips Consumer Care
Center in your country
The indicator light
flashes quickly.
There is not enough
water in the water
reservoir
Fill the water reservoir and make
sure you place the water reservoir
properly into the machine.
The float in the water
reservoir may be
stuck.
Empty the water reservoir and shake
it a few times to release the float.
Clean the water reservoir with hot
water and some washing-up liquid or
in the dishwasher.
The coffee is not
hot enough.
You need to descale
the machine.
Descale the machine according to
the instructions.
The coffee
temperature in
the cup decreases
quickly.
Do not use cups that
are too large.
Use thin-walled cups.
Thin-walled cups absorb
less heat from the coffee than
thick-walled cups.
You can preheat the coffee machine
and cup by brewing a cup of hot
water first without placing a coffee
pod in the pod holder.
Intensity select:
after pressing
the coffee button
twice, I do not get
a stronger coffee.
You have pressed
the coffee button
twice too fast or you
have waited longer
than 3 seconds after
pressing the button
for the first time.
Pressing the coffee button twice
to get a stronger coffee is possible
within a time frame of 3 seconds.
The LED light on the machine will
shine less bright if the programming
was successful.
I cannot open
the lid.
A temporary vacuum
has developed under
the lid.
Switch off the coffee machine. Pull
up the lever and wait
24 hours before you open the lid.
You may need to use some force.
Always make sure the pod holders
are clean and the sieve is not
clogged to prevent a vacuum.
The coffee
machine produces
less coffee than
before.
Perhaps the sieve in
the center of the pod
holder is clogged.
If the sieve is clogged, use a
washing-up brush to unclog
the sieve. If you cannot unclog
it properly with the washing-up
brush, put the pod holder in the
machine and descale the machine
according to the instructions.
Perhaps you have
pressed the 1 or
2-cup button twice.
This machine has Intensity Select. If
you press the button twice, you get
a smaller cup of stronger coffee.
I cannot close the
lid properly.
Perhaps a used
coffee pod is
sticking to the water
distribution disk.
If this is the case, remove the used
pod.
The coffee is not
strong enough.
You may not have
used the right number
of pods or may have
pressed the wrong
button.
Use 1 pod in combination with the
1-cup pod holder and the 1-cup
button. Use 2 pods in combination
with the 2-cup pod holder and the
2-cup button.
The pod(s) may not
have been placed
in the pod holder
properly.
Place the coffee pod(s) properly
in the center of the pod holder, to
prevent water from escaping along
the edge of the pod(s). When you use
two coffee pods on top of each other,
make sure that the convex sides of
both pods point downwards and
press the pods lightly into the pod
holder. Make sure that the coffee in
the pod is distributed evenly.
You may have used
the same pod twice.
Place a new pod in the pod holder to
brew a fresh cup of coffee.
Perhaps you need a
different flavor.
If you prefer a more robust flavor,
SENSEO® coffee pods with a
stronger blend are available.
HD6554, HD6555,
HD6556: Use
intensity select.
Press the button twice to brew
one or two small cups of stronger
coffee.
The coffee is too
strong.
Perhaps you need a
different flavor.
If you prefer a milder flavor,
SENSEO® coffee pods with a milder
blend are available.
Perhaps you pressed
the 1-cup or 2-cup
button twice.
This machine has Intensity Select. If
you press the button twice, you get
a smaller cup of stronger coffee.
Water leaks
from the coffee
machine.
You have not closed
the lid properly.
Close the lid properly and lock the
lever.
You have not placed
the pod(s) in the
holder correctly.
Place the pod(s) properly in the
center of the pod holder with the
convex side pointing downwards,
as shown in the instructions.
You overfilled the
water reservoir.
Do not fill the water reservoir
beyond the MAX level.
The sieve in the
center of the pod
holder may be
clogged.
Check the pod holder. If the sieve is
clogged, use a washing-up brush to
unclog the sieve. If you cannot clean
it properly with the washing-up brush,
put the pod holder in the machine
and descale the machine according to
the instructions.
