Philips LBB 1330, Instructions For Use Manual

Page: 52 / 140

4. OPERATING AND PROGRAMMING THE SM40 SYSTEM
4-30
4
Status / Action
If the number of a non present Master Call
Station is entered the display shows:
Otherwise, when the selected Master Call
Station is in use the display shows:
Otherwise, the display shows:
Enter the first of the range of key set inputs:
Enter the number of key sets.
If the corresponding slave Input Card is not
present the display shows:
Otherwise, when the required number of
inputs is not available the display shows:
Otherwise, when the inputs are accepted the
display shows:
Press ‘ 0 ’ to uncouple the selected range.
Otherwise, after pressing ‘ 1 ’ the display
shows:
Result / Remarks
Activating selected routing can be programmed in two separate modes:
0 Separate Mode
Five attention or alarm signals plus Digital Messages can be programmed under
keys 1 to 5 of the activation station Four priority levels can be programmed
under keys 6 to 9 of the activation station. Keys 6 to 9 will also activate the
complete pre-selection.
1 Combined Mode
Nine attention or alarm signals plus Digital Messages with a priority can be
programmed under keys 1 to 9 of the activation station. The keys will also
activate the complete pre-selection.
Note: This selection is valid for each Master Call Station connected.
ENTER SIGNAL/PRIORITY PRE-SELECTION MODE
PRESS '0' FOR SEPARATE; '1' FOR COMBINED
PRESS '1' TO COUPLE; '0' TO UNCOUPLE
MASTER: X KEYSETS: XX XX
** NOT ALL SELECTED INPUTS PRESENT **
PRESS 'ENTER'
*** ERROR *** INPUT CARD X NOT PRESENT
PRESS 'ENTER'
ENTER FIRST KEY SET INPUT (17-32):XX
ENTER NUMBER OF KEY SETS (1-16):_
ENTER FIRST KEY SET INPUT (17-32):XX
ENTER NUMBER OF KEYSETS (1-4)
*** ERROR *** STATION ALREADY ASSIGNED
PRESS 'ENTER'
*** ERROR *** CALL STATION NOT IN SYSTEM
PRESS 'ENTER'