Philips 202P70/00, Service Manual

Page: 21 / 90

Go to cover page
202P7 CRT
21
OSD Adjustments (Continued)
To access BURN IN mode
First of all, monitor displays an image.
1. Disconnect the video cable(interface cable).
2. Turn off monitor
3. Press
and simultaneously on the front control panel,
then the BURN IN mode comes on the screen of monitor as below.
50 seconds around
5 second around
repeat
4. Reconnect the video cable, then return the normal image.
SERVICE MODE (indication-factory mode)
00119: stand for
1. Using 10 hours already
2. Turn on/off 10 times.
3. Using several hours
+ turn on/off monitors.
Default setting of MODEL SELECT (Do not change it.)
MODEL SELECT
RESERVE
RESERVE
RESERVE
130K 202P7 SDI
SWDDC
RESERVE
<-------------------------
4. Using : to select OSD menu.
5. Using : to increase or decrease the setting.
6. Using : to access/confirm the selection.
To leave factory mode
7. After alignment of factory mode, turn off monitor(if you do not run
off monitor, the OSD menu is always at the factory mode), then turn
on monitor again (at this moment, the OSD menu goes back to user
mode.)