and LED off
connect to the Main
power
2. The PAN08 break
down
2. Don’t open up the PAN08 and send it
for repair.
The shutter move direction
is reverse
Wrong connection of NC
and NO to the motor
Swap the NC NO connection
PAN08 LED light work fine
But can not control
1. No association setting
2. Same frequency
interference
3. S1 or S2 are pressed in
Two Push Button switch
type, PAN08 would not
accept RF command.
1. Carry out association
2. Wait for a while to re-try
3. Release S1 and S2
Specification
Operating Voltage
100 ~240VAC
Maximum Load
Resistive load 5A max
Range
Minimum 30 m in door 100m outdoor line of sight
Operating Temperature 0°C ~ 40°C
Frequency Range
PAN08-1: 868.40MHz; 869.85MHz(EU) /
PAN08-2: 908.40MHz; 916.00MHz(USA/Canada) /
PAN08-3: 922.5MHz/ 923.9MHz/ 926.3MHz (Taiwan/JP)
** Specifications are subject to change and improvement without notice.
Warning:
1.Plug out to disconnect from power supply; Do not plug in line.
2. Do not exceed the max rating
Disposal
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
Company of License Holder
：
Philio Technology Corporation
Address of License Holder
：
8F.,No.653-2,Zhongzheng Rd., Xinzhuang Dist., New Taipei City
24257,Taiwan(R.O.C)
FCC Interference Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
13
