EN -
08/2015
Copyright © 2015, Fast ČR, a. s.
PART
: TROUBLESHOOTING
The appliance may only be repaired by an authorised service centre.
Before calling the authorised service centre, check whether you can remedy the problem yourself by reading
the instructions or proceeding according to the operating instruction.
You may be charged repair fees even within the scope of a valid warranty.
Error messages
Error
message
Description
Possible causes
F5
Insuffi
cient water supply
•
Check that the water inlet is fully open and that the
water supply was not interrupted.
•
Shut off the water inlet. Unscrew the water supply hose
and clean out the fi lter on the end of the hose.
•
Restart the dishwasher, contact an authorised service
centre.
F3
Water supply failure
•
Shut off the water inlet.
•
Contact an authorised service centre.
F2
It is not possible to pump residual
water out of the dishwasher.
•
The drain hose is clogged.
•
The fi lters may be clogged.
•
Turn off the dishwasher and start the cancel wash
programs.
•
If the problem persists contact an authorised service centre.
F8
Malfunction of the heat element
•
Contact an authorised service centre.
F1
The warning indicator is activated
when the dishwasher overfl ows.
•
Turn off the dishwasher and close the water inlet.
•
Contact an authorised service centre.
FE
Faulty electronic card
•
Contact an authorised service centre.
F7
Overheating (the temperature
inside the appliance is too high)
•
Contact an authorised service centre.
F9
Partition position error
•
Contact an authorised service centre.
F6
Faulty heating element sensor
•
Contact an authorised service centre.
Status indicator is lit and the start / pause indicator is fl ashing.
•
The dishwasher door is open.
A program did not start.
•
Check that power plug connected to the power socket.
•
Check the house wiring fuse.
•
Make sure that the water inlet is open.
•
Make sure that you have closed the dishwasher door.
•
Make sure that you have turned on the dishwasher using the On/Off button.
•
Make sure that the fi lters on the supply hose and at the inlet to the dishwasher are not clogged.
The washing indicator does not turn off at the end of a wash.
•
The On/Off button has become loose.
