EN – 18
ATP
2033 and 2063 m
3
/h SD, C1 series
pumps are tested in the factory with
A120
oil
(
A119
for the US).
2033 and 2063 m
3
/h C2 series
pumps are tested in the factory with
A113
oil.
At delivery, there is some oil remaining in the functional block.
Filling with oil
Mineral oil:
ELF MOVIXA PV 100, TURBELF SA 100,
BP CS 100 (BP registered trademark)
SHELL VITREA 100 (SHELL registered trademark)
TOTAL CORTIS PV 100 (TOTAL registered trademark)
INLAND 19, INLAND 20 (INLAND registered trademark)
MR 200 (MATSUMURA registered trademark)
Mineral-based synthetic oils:
ELF BARELF F 100, ELF BARELF C 68 (ELF registered trademark)
INVOIL 20 (INLAND registered trademark)
INLAND TW (INLAND registered trademark)
ELITE Z (CAMBRIGE MILL PRODUCTS, INC. reg. trademark)
Ester type synthetic oils:
ANDEROL 555 (ANDEROL-BV registered trademark)
ANDEROL RCF 96 N (ANDEROL-BV registered trademark)
Fluorocarbon synthetic oils:
FOMBLIN YL VAC 25-6 (MONTEDISON registered trademark)
KRYTOX 15-25 (DU PONT DE NEMOURS registered trademark)
HALOVAC 100 (HALOCARBON registered trademark)
AFLUNOX 15.25 (SCM registered trademark)
Note: In this case, pump performances may be slightly different from those given in
pages
11
and
12
.
However, the following
replacement fluids can be used:
Our pumps are tested in the factory with adixen’s oil: it is recommended to
use the same oil during operation. To change the type of oil, refer to the
Maintenance Chapter, “replacement of oil type” section.
In all cases, follow the recommendations of the pump specifier for the
choice of oil to be used.
The pumps are delivered without an oil charge: the oil is delivered in
separate containers.
Wear a mask, gloves, protective glasses to fill in or drain the oil in the
pumps.
In the same way, it is recommended to drain the pump before returning
the equipment.
Recommended oils
(cont’d)
