CIRCULAR SAW TLC 800/900/1000/1200 vertical
62
Chapter 15
ROUTINE MAINTENANCE
ADJUSTMENT OF THE BELTS TENSION (P.T.O. VERSION)
WARNING:
Before every adjustment and maintenance operation to be sure that
the current is disconnected (electric engine). Stop the tractor’s
engine (PTO).
15.2 Adjustment of the tension of the
angle set’s belts
N.B. Disconnect the current rotating
the general switch in the position 0.
Close the switch.
■
Disassemble the carter on the back side of
the machine.
■
Check the tension of the belts pressing
with your hand. If the belt low itself more
than 15 mm. you must adjust the tension.
■
Loose the screws of the angle set’s support
bracket (A)
■
Loose the nut (C)
■
Screw the screw (B) checking the tension.
■
Block the angle set’s support screwing the
two screws (A).
■
Block the nut (C).
MAX 15 mm.
T
C
B
A
Summary of Contents for TLC 1000
Page 2: ......