WORKING ON THE ABS/PBS SYSTEM
Page : 37
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
Bleeding the circuit after removing a front or rear caliper, a front or rear lower hydraulic hose
Operation 1
- Remove the cover from the master cylinder to be bled
- Protect any plastics which may be exposed to brake fluid splashes
- Remove the caliper bleed screw cap
Note:
If the integral circuit is to be bled (left
lever), the right lever must be immobilised with a
hook or cable tie (as described in the note on page
30).
- Connect the bleed screw to a recipient containing
brake fluid using a transparent pipe. The recipient
must be kept higher than the brake caliper to
facilitate checking that the air bubbles are being
expelled.
- Open the caliper bleed screw half a turn
- Position the handlebar in order to set the master
cylinder horizontal
Important:
It is essential to avoid being under the
master cylinder during bleeding to avoid brake
fluid splashes
