WORKING ON 4-STROKE INJECTION SYSTEMS
Page : 21
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
To remove the throttle housing and idle valve
- Remove the ignition key
- Remove the battery covers
- Disconnect the atmospheric pressure sensor (1)
- Disconnect the oil vapour recycling hose (2)
- Slacken the screw-type clip (3) from the throttle
housing lug and inlet silencer
- Remove the inlet silencer 2 fixing bolts (4)
- Remove the inlet silencer (5)
- Disconnect the throttle cable (6)
- Disconnect the throttle unit (7) and the idle valve
(8)
- Unclip the clip type hose clip
- Remove the throttle unit
Reassembly:
Proceed in reverse order to
disassembly ensuring:
- the throttle unit positioning pin (A) is properly
located in its housing on the inlet manifold
- the accelerator cable is properly tensioned
- Use the diagnostic tool to initialise the throttle
unit (refer to the documentation "Using the
Diagnostic Tool for the Injection Engine)
Check:
Using the diagnostic tool, check for fault
codes, clear them if necessary
