WORKING ON THE ABS/PBS SYSTEM
Page : 32
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
To refit the control unit
- Fill the control unit reservoir with new brake
fluid to within 10 mm of the top lip
- Fit the filter, cap and clip
- Fit the control unit on its mounts but do not
tighten it
Note:
Fit new copper seals each time it is removed
- Fit the hydraulic hoses in the following order:
•
The hydraulic hose (1) from the left master
cylinder
•
The hydraulic hose (2) to the rear brake caliper
and fit it over hydraulic hose (1)
•
The hydraulic hose (3) from the right master
cylinder
•
The hydraulic hose (4) to the front brake
caliper
- Connect the control unit (5)
- Connect the feed pipe (6)
- Remove the feed hose clamp
- Release the control unit from its mounts so that it
is as vertical as possible
- Bleed the hydraulic system using the correct
method
