10
10
PRACTICAL INFORMATION
117
CHANGING A REAR BULB
(407 SW)
Left and right fog lamps:
P21 W.
Carefully unclip the tailgate interior
trim.
Detach the sealing sheet located
behind the light concerned.
Remove the bulb holder turning it a
quarter of a turn.
Change the faulty bulb.
When refi tting, ensure that the bulb is
positioned correctly in the bulb holder.
Unclip the light (2 clips).
Disconnect the connector and re-
move the light.
Unclip the bulb holder moving
aside the 4 tabs.
Unscrew the bulb and change it.
Reconnect the connector.
Lock the bulb holder in place.
When refi tting it, ensure that the
lamp is correctly positioned and
secured, reclipping the rear part
then the front part.
Number plate lights:
W 5 W.
Insert a thin screwdriver in one of
the exterior holes of the transpar-
ent cover.
Push it towards the outside to un-
clip it.
Remove the transparent cover.
Change the faulty bulb.
Third brake light (diodes)
All work on the diode lights must be
carried out by a PEUGEOT dealer.
Wing lights
1.
Brake lights/side lights:
P21/5 W.
2.
Reversing lights:
P21 W.
3.
Direction indicators:
P21 W.
These three bulbs are changed by
removing the light.
Remove the corresponding boot
side fl ap to gain access to the
light.
Remove the light fi xing nut inside
the boot.
Note:
if necessary, use the wheelbrace
to remove the nuts.
In some climatic conditions
(e.g. low temperature or hu-
midity), the presence of misting
on the internal surface of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.
Summary of Contents for 407 2009
Page 15: ...1 INSTRUMENTS and CONTROLS 18...
Page 34: ...3 COMFORT 34...
Page 161: ...11 11 TECHNICAL DATA 139 DIMENSIONS IN MM 407 saloon 407 SW...
Page 175: ...153 03 GPS...
