Petwalk Solutions petWALK, User Manual

Page: 51 / 72

Seite 51 von 72 User Manual Petwalk Solutions GmbH
7 OVERVIEW OF THE MOST IMPORTANT PROGRAMMING STEPS
Setup mode
1x MENU BUTTON
Programming mode
2x MENU BUTTON
Adjusting the time
1x MENU BUTTON – TIME PROGRAM – select 12-hour or 24-hour mode – OK .
Adjust hours with UP / DOWN – OK ,
Adjust minutes with UP / DOWN – OK
Adjusting the door
opening time
1x MENU BUTTON – OPEN DOOR – UP / DOWN : Set value between 02 and 98 –
OK
Adjusting the range of
the motion sensors
1x MENU BUTTON – OPEN DOOR – OK : INNER range: Set value between 1 and 98 –
OK . OUTER range: Set value between 1 and 98 – OK
Adjusting the volume of
the sound indicator
1x MENU BUTTON – UP / DOWN : Set volume – OK
Adjusting the door
lighting
2x MENU BUTTON – UP / DOWN until [LIGH] – OK : Set value – OK
Adjusting the door
opening angle
2x MENU BUTTON – UP / DOWN until [DOOR] – OK : Learning mode [RUN] starts
until obstacle is hit – adjust value with UP / DOWN – OK
Programming the
time window for entry
control
Set starting time: MENU BUTTON – ACCESS CONTROL – Set hours with UP / DOWN
– OK – Set minutes with UP / DOWN – OK – Set ending time: Set hours with
UP / DOWN – OK – Set minutes with UP / DOWN – OK
Programming the time
window for exit control
Set starting time: MENU BUTTON – EXIT CONTROL – Set hours with UP / DOWN –
OK – Set minutes with UP / DOWN – OK – Set ending time: Set hours with UP
/ DOWN – OK – Set minutes with UP / DOWN – OK
Programming an RFID
chip
1x MENU BUTTON – ACCESS CONTROL – OK : Door is in learning mode.
Setting up different
permissions for
multiple RFID chips
Select the desired (programmed) chip:
1x MENU BUTTON – ACCESS CONTROL – UP / DOWN until the desired chip
number – OK
RFID-Chip/Animal is always allowed to enter:
ACCESS CONTROL green – MENU BUTTON
RFID-Chip/Animal may never enter:
ACCESS CONTROL red – MENU BUTTON
Permission is tied to the programmed time window:
ACCESS CONTROL orange – MENU BUTTON
RFID-Chip/Animal is always allowed to exit:
EXIT CONTROL green – MENU BUTTON
RFID-Chip/Animal may never exit:
EXIT CONTROL red – MENU BUTTON
Permission is tied to the programmed time window:
EXIT CONTROL orange – MENU BUTTON
Programming the
brightness sensor
1x MENU BUTTON – BRIGHTNESS – UP / DOWN set desired value – OK – select
desired ACCESS CONTROL/EXIT CONTROL – OK
Programming the door
contact
2x MENU BUTTON – UP / DOWN until [dId] – OK – UP / DOWN until
[noPE] or [ncLo] – OK
Switch off BATTERY
2x MENU BUTTON – [ACCU] – OK – UP / DOWN until [on] or[off] – OK
Reset to factory
settings
Erase all settings, but not the saved RFID transponders:
2x MENU BUTTON – UP / DOWN until [PAR] shown on display – OK .
Erase all settings / Reset to factory settings:
2x MENU BUTTON – UP / DOWN until [ALL] shown on display – OK .
Exit the setup /
programming menu
1x MENU BUTTON