Seite 46 von 72
User Manual
Petwalk Solutions GmbH
Press
OK
. The petWALK pet door is now ready to be programmed. The next free memory location is displayed
and the “P” for programming indicates that the door is ready to be programmed. The display will now appear as
follows (note: program “P 01” if it is the first attempt):
Move the RFID chip or the chipped animal about 2 cm / 0.8 in away from the door leaf. You will hear a beep
to indicate that the chip was successfully registered. The “P” will vanish and the number on the display
will increase by 1, thereby showing the next free memory location. The petWALK pet door now has all the
information it needs to open solely for your pet.
You can exit the setup mode by pressing the
MENU
button twice. You will automatically be redirected to the
operating mode that was active before you programmed the RFID chip.
HINT!
If you try to program a previously programmed RFID chip a second time, the display
will show the number of the previously programmed RFID chip. You will also hear a
quiet beep. This way, you can check that the RFID chip was programmed correctly.
In case you want to program another chip to the door, you will have to press the
OK
button again, so that the letter „P“ appears on the display. Forgetting to
press the
OK
button is one of the most common reasons why customers call for
assistance during the setup process.
6.5 WHAT THE DISPLAY TELLS YOU ABOUT GRANTING AND DENYING RFID ACCESS
It is important that whoever sets up the door and trains the pet understands the symbols on the display and
their meaning when lit up in different colours to ensure that your pet‘s acclimatisation period is as stress-free as
possible. In basic RFID mode with no other settings activated, the display looks like this:
When your pet approaches the petWALK pet door, the access control icon will flash orange as soon as the
petWALK pet door identifies movement inside or outside. The flashing indicates that the petWALK pet door is
trying to read the RFID chip. If the petWALK pet door identifies the chip, it will open. If no known RFID chip can
be identified after about 20-30 seconds, the open door icon will glow red for about 2 seconds. (Note: doors
shipped before 2021 will glow red if no RFID chip could be found after 10 seconds). During this period of time,
the petWALK door stays locked. Once the door icon on the display turns green, the door is able to identify RFID
chips again.
If your pets stops and waits too far away from the petWALK pet door (outside of the RFID range), the distance
might be too large to successfully identify an RFID chip. Therefore, you should use the motion sensor function
initially until your pet is used to the petWALK pet door.
6.6 DIFFERENT SETTINGS FOR RFID ACCESS FROM THE INSIDE AND OUTSIDE
You can determine whether the RFID access control is active for both sides or only for exit control or entry
control. However, when it is only active on one side, the motion sensors will be active on the other side. As
standard, the petWALK pet door has been programmed so that the
ACCESS CONTROL
icon will glow green
whilst in RFID operating mode and RFID access control will be active on both sides of the door.
Should you wish to change this setting, press the
MENU BUTTON
on the remote control twice in quick
succession to access the programming mode. Either “DOOR”, “LIGH”, “did” or “rFid” will flash. Press the
UP
and
DOWN
buttons until “rFid” is displayed.
Summary of Contents for petWALK
Page 1: ...User Manual VERSION 4 1...
