![Petwalk Solutions petWALK User Manual Download Page 36](http://html1.mh-extra.com/html/petwalk-solutions/petwalk/petwalk_user-manual_1533144036.webp)
Seite 36 von 72
User Manual
Petwalk Solutions GmbH
to operating mode that was active before the door opening angle was adjusted. From now on, the petWALK pet
door will only open as wide as the value you have just set in the learning mode.
HINT!
•
Should you have trouble entering the programming mode by pressing
the MENU button twice, it might be helpful to try pressing it twice with
your „weaker“ hand instead, meaning the left hand for right handers and
viceversa.
•
In learning mode, the petWALK pet door saves a slightly smaller angle than
the opening angle at which an obstacle blocked the door. As a result, the
next time the door opens, it will not come into contact with the obstacle
again and there should be no need for any further adjustment.
•
Over time, the opening angle of the petWALK pet door can change as a result
of external factors. This is not an error. Check the opening angle from time to
time and if necessary, adjust the angle as described above.
•
Should the value 99 appear whilst you adjust the opening angle, the slip
clutch might have loosened.
5.5 ADJUSTING THE DOORWAY LIGHTING
We have built lighting for your pets into the entrance area of your petWALK pet door. The doorway is lit up whilst
the door leaf is open. You can select the brightness level that fits your needs - from 0(off) to 5 (brightest). The
default setting is level 5 - the brightest setting.
To change the brightness, press the
MENU BUTTON
twice in rapid succession to access the programming
mode. The display will appear as follows:
Using the
UP
and
DOWN
buttons, scroll until LIGH appears on the display.
Now press
OK
. The current brightness level will be displayed. Now you can select the brightness level you
desire by using the
UP
and
DOWN
buttons. The doorway light will now shine at the selected brightness.
Once the doorway is lit to your satisfaction, you can save the setting by pressing the
OK
button. From now
on, the doorway will be lit at the level you have just set. You can exit the programming mode by pressing either
the
MENU BUTTON
or the
OPERATING MODE
button.
Summary of Contents for petWALK
Page 1: ...User Manual VERSION 4 1...