PERODUA ALZA, Owner'S Manual

Page: 424 / 508

11–10
2. Four jack setting points are provided: two
on each side as shown in the illustration.
Set the jack at the jack setting point that
is nearest to the flat tyre.
WAANINNG
w
To prevent accidental slip of the jack
and serious bodily injury;
• The jack should be used on level
firm ground whenever possible.
Place a flat and wide board
underneath the jack, if necessary,
to stabilize the jack.
• It is recommended that the wheels
of the vehicle be chocked, and that
no person should remain in the
vehicle that is being jacked.
• No person should get their bodily
under a vehicle that is supported
only by a jack; use vehicle support
stands.
• Never place any portion of your
body under the jacked up vehicle.
• Use the jack provided with your
vehicle only for the purpose of
changing wheels.
• Do not raise other vehicles or loads
at any time with it.
• Set the jack at the specified point.
• Do not rock or push a vehicle that
is jacked up.
• Do not run the engine when the
vehicle is jacked up.
• Take heavy luggage out from the
vehicle as much as possible.
3. Insert the jack handle into the worm shaft
of the jack and turn it clockwise to raise
the vehicle.
Jack up the vehicle gently until the tyre
clears the ground surface only enough to
remove and install the tyre.
WAANINNG
w
Place the spare tyre under the vehicle
body at a point near the tyre to be
changed.
This is a precautionary measure that
may be helpful to avoid danger in the
event that the jack is detached.
Sect 11 EN.indd 10 03/07/2018 5:14 PM