33
Electric seat lift
Assembly
Assemble in the’reverse order.
1.
Fit the seat lift into the chassis using the four
screws (see fig. below). If the wheelchair is
equipped with seat support, mount it. See
page 36.
2. VR2
Connect the seat lift cabling at the connector
on the cabling.
R-net
Connect the seat lift cabling to the ICS general
module.
3.
Fit the seat including the seat tilt mechanism if
the wheelchair is equipped with such device.
See page 36-40.
ICS General Module.
Electric seat lift
4.
Fit the upper chassis cover. See page 9.
ICS General Module is fitted at
the rear of the chassis.
For this task the following tools are necessary:
1 Allen key 5 mm.
The seat is heavy. This work should therefore
always be performed by two people. Be careful
with the cabling.
m
WARNING!
Summary of Contents for ConnectMe M400
