26
Wheel forks
Wheel forks
Removal
1.
Switch off the main power switch on the control
panel.
2.
Lift up and chock up the wheelchair chassis so
that the wheel in question is free of the ground.
3.
Remove the wheel. See page 20.
4.
Remove the cover (1) on top of the link arm.
5.
Remove the wheelfork, it’s fitted with the
screw (2) and washer (3) from above (see fig.).
Also remove the friction brake (4) by pulling it
straigt out of the bearing house of the link arm.
Assembly
Assemble in the reverse order.
1.
Check that the wheel fork and link arm with
bearings and friction brake are not damaged.
If necessary, clean to remove dirt and rust.
Replaced damaged parts.
2.
Fit the wheel fork on the linkarm using just
your hands. Check that the wheel fork is fully
located on the linkarm.
3.
If needed, clean the friction brake and then
lubricate it with Friction brake grease, order
no: 1820405 before fitting it in the bearing
house of the link arm, see page. 27.
4.
Fit the screw (2) and washer (3) from above (see
fig.). Tighten the screw with a torque wrench.
Tightening torque: 17.7 ft-Ibs (24Nm)
Wheel fork.
1
Cover
2
Screw, ISO 4762 M8x20 8.8 FE/Zn
3
Washer, ISO 7089 8 200 HV Fe/Zn (8,4x16x1,6)
4
Friction brake
5
Bearing, 6002-2RS1 (15x32x9)
6
Link arm
7
Spacer, Ø16xØ22x12,5
8
Wheel fork
Item
Description
2
8
5
6
7
3
1
4
Do not use an impact wrench for the tightening torque.
m
CAUTION!
For this task the following tools are necessary:
1 Allen key 6 mm.
5.
Fit the cover (1) on the link arm (see fig.).
6.
Fit the wheel. See page 20.
Summary of Contents for ConnectMe M400
