1
. Raise the seat angle.
2.
Switch off the main power switch on the
control panel.
3.
Remove the control panel. See page 42-43.
Cut off the cable ties holding the cabling in
place on the seat, noting the position of the
cable ties for subsequent fitting.
4.
Separate the cabling for the seat angle mechanism
at the contact on the cabling. The contact is at the
front right corner of the seat angle mechanism,
next to the other cabling (see fig.).
4.
Remove the four screws holding the seat (see
fig. below).
4.
Lift the seat off.
41
Seats
Seats
Removal of PS on chassis with seat
angle mechanism.
The seat is fitted with four screws.
Assembly of PS
Assemble in the reverse order.
1.
Position the seat and fit with the four screws (see fig.). Tighten the screw with a torque wrench.
Tightening torque: 17.7 ft-Ibs (24Nm)
2.
Connect the cabling for the seat angle mechanism at the contact on the cabling. The contact is at the
front right corner of the seat angle mechanism, next to the other cabling (see fig.).
3.
Fit the control panel. See page 42-43. Fit the cabling with cable ties.
For this task the following tools are necessary:
1 Allen key 5 mm.
The connector is on the cabling at the front
right corner of the seat angle mechanism, next
to the rest of the cabling
The seat is heavy. This work should therefore always be performed by two people. Be careful with the cabling.
m
WARNING!
Summary of Contents for ConnectMe M400
