Permobil C400, Service Manual

Page: 83 / 132

Permobil C400 Corpus 3G Lowrider Repairs
tighten the screws. Tightening torque 9.8 Nm.
Figure 127. The connector is on the cabling at the front
right corner of the seat angle mechanism, next to the rest
of the cabling.
3. Connect the cabling for the seat angle mechanism to
the wheelchair's ICS Master Module. If the cabling for
the ICS Master Module is already there, connect it to
the contact that is at the front right corner of the seat
angle mechanism, next to the other cabling. See fig.
127.
When mounting new cabling for the ICS Master Mod-
ule, mount it together with the rest of the cabling run-
ning down to the wheelchair chassis and there
connect it to the ICS Master Module. For further infor-
mation on the ICS Master Module, see the chassis
service manual.
Figure 128. The seat plates are held in place by two
screws at the back edge and two quick-mount clamps at
the front.
4. Mount the seat plates by first mounting them with the
quick-mount clamps at the front and then the screws
at the back. Fit the quick-mount clamps by pushing
them straight into the holes.
83