Permobil C400, Service Manual

Page: 100 / 132

Permobil C400 Corpus 3G Lowrider Adjustments
Seat width
Figure 157. The seat plates are held in place by two
screws at the back edge and two quick-mount clamps at
the front.
For this task the following tools are necessary:
• 1 Allen key 3 mm.
• 1 Allen key 6 mm.
The seat width can be adjusted to give the user optimal
comfort. There are four fixed levels, each 25 mm apart.
1. Remove the seat cushion by lifting it straight up. It is
attached by means of Velcro on the rear of the
cushion.
2. Remove the seat plates, which are held in place by
two screws at the back edge and two quick-mount
clamps at the front. See fig. 157. First remove the
screws, then use your hand to carefully push the seat
plate from below to release the quick-mount clamps
at the front.
Figure 158. The seat width is fixed using four screws.
3. Remove the four screws securing the seat width ad-
justment unit. See fig. 158.
4. Adjust the seat width by moving the right or left sec-
tion of the seat frame to the required position. The
rails with which the seat width is adjusted are marked
with the settings for each potential position. The scale
is marked with "millimetres" and "inches".
5. Secure it at the required setting by replacing the four
screws.
6. Remount the seat plates using two screws at the back
edge and two quick-mount clamps at the front. See
fig. 157.
7. Fit a cushion of a suitable length/width for this setting.
See
Recommended cushions, seat plates and Uni-
Track rails , Page 129. Secure the cushion in place us-
ing the Velcro on the back of the cushion.
100