perma STAR CONTROL TIME
- 17 -
7.3.2
Changing the discharge volume after the perma STAR CONTROL TIME
has been in operation/reset function
With the reset-function, the lubricator can be returned to its initial state by
resetting the internally saved parameters.
a) Unplug the power plug from the lubricator.
b) Unscrew the lubricator from the lubrication point.
c) Unscrew the LC unit from the drive unit.
d) Put dip switches 3+4 “VOL”
of the 4-way code switch to this position (Reset).
e) Attach the power connector to the drive unit.
f) As soon as the motor has run for 2 sec, both LED’s will light up.
Pull the plug from the drive unit.
g) Set dip switches “TIME” and “VOL” of the 4-way code switch
according to chapter 7.3.
h) Again, push and hold the white peg on the bottom of the drive unit (see picture
below).
i)
Attach the power connector to the drive unit.
j)
After 3 seconds, release the peg and unplug the power connector.
k) Mount the drive as described under point 6.2.
NOTE: Changing the discharge volume as described above may result in an
incorrect LED display of “LC unit empty” which depends on how empty the
attached LC unit was before the discharge volume was changed. Therefore it is
important that you manually monitor the End of discharge period.
Reset-peg
Vol.
3 4
