PerkinElmer SPECTRUM TWO N, User Manual

Page: 36 / 125

36 . Spectrum Two N User's Guide
4. Continue the Spectrum software installation, following the instructions displayed
on-screen.
You are now ready to start Spectrum software. The first time you log on to Spectrum with a
Spectrum Two instrument connected to the PC via a USB cable, the instrument is installed
and configured automatically.
NOTE: For AssureID, install the USB drivers, connect your spectrometer as shown in
Figure 14, start AssureID, and then run the Instrument Install Wizard (see page 42).
Refer to the
AssureID Administrator’s Guide
(part number L1050019) for more
information.
Connecting the spectrometer to the PC using the
wireless router
The following procedure describes connection using the PerkinElmer-configured wireless
router (not supplied with the instrument). The wireless router is powered by the EXT
DETECTOR port on the rear of the Spectrum Two N instrument. The cable required is
supplied with the wireless router.
NOTE:
If you are powering your instrument using the optional Spectrum Two N Battery Pack
(part number L1600233), powering the wireless router will reduce the runtime of the
battery.
1. Unpack your wireless router, and position it near the instrument.
2. Connect the wireless router to the EXT DETECTOR port at the rear of the spectrometer
using the cable supplied (part number L1602706), as shown in Figure 16.
Figure 16 Wireless router connected to the EXT DETECTOR port
EXT DETECTOR port
POWER port