Installation and Operation Manual
for Perenio® Power Link Devices
©Perenio IoT spol s r.o. All rights reserved
Doc Version: 1.4.3
Page 19 of 49
2.1 Initial Installation and Configuration
2.1.1 Powering On the Device
To power on the device, it is enough to unpack it, plug into the electrical socket and
press the Power Button so that the LED Indicator lights up (or blinks slowly) green.
After that you can connect household appliances to the device.
Figure 5
– Connection to the mains socket
2.1.2 Selection of the Connection Method
There are two modes when activating the power plug in the Mobile Application:
Zigbee Mode that is used for activation in the Perenio Smart App through the
Control Gateway or the IoT Router, including further activation of this device in
Google Home and/or Yandex Smart Home applications;
Bluetooth (MFi) Mode that is used for activation in Apple HomeKit without the
Perenio® Control Gateway or the IoT Router.
When you first switch on the Power Link device, or did not activate it in the Perenio
Smart App through the Control Gateway or the IoT Router, the default mode will be
the Bluetooth (MFi) Mode.
However, after it is activated in the Perenio Smart App through the Control Gateway
or the IoT Router, the Power Link device will automatically switch to the Zigbee Mode
and will not be available for connection in the Apple HomeKit application.
The device may be switched from Zigbee Mode to Bluetooth (MFi) Mode in one of the
following ways:
1.
Find the power plug in the Devices tab, click on the Settings icon ( ), and select
“Disconnect device” to remove it from the Perenio Smart App.
