PERCo TTR-07.1, Assembly And Operation Manual

Page: 21 / 34

Assembly and Operation Manual
8. Check serviceability and accuracy of all the electrical connections.
9. Fasten all the cables in two points to the hole in the turnstile housing horizontal plane,
using hook and loop cable ties.
10. Connect the indication board cable header to the control mechanism connector and
mount the cover with LED indication display
(2) back into its place in the reverse order.
When the cover with LED indication display (2) mounting is carried out correctly it does not
need much effort. Fasten the cover with a bolt.
11. Run a test switch on of the turnstile as specified in Chapter 9.
12. Check operation of the intrusion detector and siren (if included in the delivery set) by
the way described below.
13. After the power-up wait until the moment of the test indicator (inside the intrusion
detector) going off (from 10 to 50 sec), the turnstile should be in the “Always locked” mode
(at the pulse control mode) or in the "Both directions closed" (at the potential control
mode)). Put your hand before the intrusion detector. The continuous signal will sound
when the intrusion detector activates. To eliminate that sound signal press any button on
the RC panel. The sound will stop without pressing the button in 5±0.5 sec.
14. Set the mounted barrier arm into the run position. The arm should be fixed
automatically.
15. Install the Ø30 plugs (14).
16. Install Ø16 plug (included in the standard delivery set) into the hole for a screw
fastening the turnstile cover, located on the housing.
17. Once the installation has been completed, the turnstile is ready for operation.
Table 1. Connection layout description
Legend Item Quantity Note
А 1 Electromagnet 1
А 2

, А 3

Remote indicators
2 RI A, RI B
А 4

Remote indicator power supply 1
А 5

Siren, 12V DC 1
А 6

Turnstile power supply 1 12V, 6 А
А 7 CLB 1 CLB.140
А 8 Indication module 1
А 9 Motor 1
А 10 Optical arm rotation sensors 1
А 11 RC panel 1 H6/4
А 12

Wireless remote control kit 1 MSRF-4
А 13

Access control system 1
А 14

Emergency unblocking device (“Fire Alarm”) 1
А 15

Intrusion detector 1 CLIP-4
1 Indication cable TTR-07.658.00 1
2
Wire jumper. Installed when the emergency unblocking
device (
А 14) is not connected
1
Installed on
default
3
Wire jumper. Installed when the intrusion detector ( А 15)
is not connected
1
Installed on
default

Supplied on request
20