Assembly and Operation Manual
8.2 Installation tools
1.2÷1.5 kW hammer drill;
Ø16 mm hard-alloyed drill bits;
Floor chaser for electric raceway;
Flat slot screwdriver No.2;
Cross-head
screwdriver;
Horn-type and socket wrenches: S17, S13 and S10;
Set square 90º;
Plumb line and level;
Measuring tape (2 m);
Hard wire 1.5 m long for cable pulling
Slide
caliper.
Note:
It is allowed to use other testing equipment and measuring tools provided
the equipment in use ensures the required parameters and measurement accuracy.
8.3 Length of cables
The maximum allowed length of the RC panel
/
WRC
/
ACS controller cable is no more
than 50 m.
The maximum allowed length of the turnstile power cable depends on the cable cross-
section and should be:
for cable with 1.5mm
2
cross-section (AWG 15) ........................................ max. 10 m;
for cable with 2.5mm
2
cross–section (AWG 13) ........................................ max. 15 m
When selecting the cable cross-section please consider the voltage loss on the cable at
maximal load current 6 A for compliance with Chapter 3 (turnstile operating voltage).
8.4 Installation procedure
The following installation procedure complies with given installation recommendations (see
clause 8.1).
1. Unpack the turnstile; check the completeness as per Chapter 3 of the Certificate.
2. Make the holes for anchor bolt (13) sleeves for the turnstile housing installation (Fig.
10). If you lay out cables under the floor surface, make an electric raceway to the cables
laying zone of the turnstile housing (option 1 or 2 in Fig. 10)
Note:
Material, cross-section, measure, variant of cable laying (external, sunken,
combined), placement on the entrance point and other cable duct parameters are
specified by the Customer according to entrance point configuration, equipment
disposition and other exploitation factors.
3. Insert sleeves for anchor bolts into the holes so that they do not stick out above the floor
surface. Set up the housing and fix it with the M10 bolts. Fix the housing after laying the
cables in the electric raceway and inside the turnstile housing.
4. Set in a working position the hab with barrier arms and secure it fastening bolts.
18
Summary of Contents for TTR-07.1
Page 32: ......
Page 34: ...www perco com...