Operation manual
18
After the power-up wait until the moment of the test indicator (inside the intrusion detector)
going off (from 10 to 50 sec, the turnstile should be in the “Always locked” mode (at the pulse
control mode) or in the "Both directions closed" (at the potential control mode)).
Put your hand before the intrusion detector. The continuous signal will sound when the
intrusion detector activates. To eliminate that sound signal, press any button on the RC-panel.
The sound will stop without pressing the button in 5±0.5 sec.
16. Once the installation has been completed, the turnstile is ready for operation.
Note. ACS reader mounting:
Inside the turnstile sections, it is possible to install access card readers as manufactured by
PERCo
(
IR03.1
,
MR07 OEM
,
RP-15.2
), and third-party manufacturers. The choice of the
type of readers, their acquisition and installation into the product is carried out by the
customer (installer) in accordance with the design of the pass-through and the
characteristics of the access control system and the control controller. Access cards readers
of
are not included
in the standard delivery set of the turnstile!
Readers must meet the following requirements:
Overall dimension (L × W × H) ......................... max 150×50×28
mm or 100×130×28 mm
Read range ..................................................................................................... min 50 mm
The brackets are equipped with threaded bushings for attaching the readers of the
RP-15
type. For
other types of readers, they can be mounted on brackets using double-sided tape or by drilling
holes in place. Readers
MR07 OEM
are installed directly on the turnstile cover from the bottom on
double-sided tape, while the installation location must be calculated so that they do not interfere
when the cover is closed (see Fig. 12).
All readers must be installed symmetrically relative to the groove in the bracket. The length of the
cable from the reader should provide the ability to connect it to the ACS controller.
Fig.12 ACS reader mounting
1 – bracket; 2 –
IR03.1
,
RP-15.2
or third-party manufacturers reader; 3 –
MR07 OEM
reader
