Assembly and Operation Manual
36
8.7.5 Installation and dismantling of the filling glass
Attention!
In order to avoid injuries,
ensure
to disconnect the speed gate from the main and backup
power before work!
Follow these steps to install the filling glass:
1. Loose the two M5 screws (4) that are located under the central insert on the sides by using S8
socket wrench (see Fig. 23).
2. Carefully install the filling glass with curly cutouts on the sides into the gap that is located in
the center of the central insert all the way in.
3. Check that the glass is installed upright and align it if necessary. Tighten the mounting screws.
Dismantling of the filling glass needs to be done in the reverse order.
Figure 23. Dismantling of the filling glass
