Pepwave MAX, User Manual

Page: 84 / 121

http://www.pepwave.com 84 Copyright @ 2013 Pepwave
Once you click on Add Rule the following window will appear.
Rules are matched from top to the bottom. If a connection matches any one of the upper rules, the
matching process will stop. If none of the rules is matching, the
Default rule will be applied.
By default, the Default rule is set as Allow for both outbound and inbound accesses.
Inbound / Outbound Firewall Settings
Rule Name
This setting specifies a name for the firewall rule.
Enable
This setting specifies whether the firewall rule should take effect.
When Yes is selected, the firewall rule takes effect. If the traffic matches the specified
Protocol/IP/Port, actions will be taken by Pepwave MAX based on the other
parameters of the rule.
When No is selected, the firewall rule does not take effect. Pepwave MAX will
disregard the other parameters of the rule.
WAN Connection
This setting is applicable to Inbound Firewall Rules only.
This setting specifies which WAN connection(s) the rule applies to:

WAN 1

WAN 2

Wi-Fi WAN

Cellular 1

Cellular 2

USB
A value of WAN 1, WAN 2, Wi-
Fi WAN, Cellular 1, Cellular 2, … and USB
specifies that
the rule applies to all WAN connections, Ethernet WAN, PC Card, … and Wi-Fi WAN,
respectively.
Protocol
This setting specifies the protocol to be matched by the rule.
Via a drop-down menu, the following protocols can be specified:

TCP

UDP

ICMP

IP