Pentair PROSTOP-E, Installation And Operation Manual

Page: 7 / 46

7
HYP1100 (04-08-21)
INSTALLATION
12. Connect the Adpater Harness's eight-pin connector (Fig.
2, Item 1) into the the first Cannode Tap Cable (Fig. 4, 2520-
0251). If the cannode(s) cannot be reached, a Cannode
Extension Cable can be used (2520-0254, 2520-0255,
2520-0256, 2520-0257).
13. Document each cannode identifier and password, from
the printed decal on the back of the component (Fig7).
Keep this information for use in subsequent setup steps.
This information can be used for Bluetooth
communication with the ProStop-E valves through the
Pentair-Hypro Spray It application.
14. Mount the cannode(s) in a central location, which can be
reached by the wiring harness from step 12. Leave ~3”
(75mm) between each cannode for wire clearance. It is
recommended to mount the cannodes, so their location
corresponds to the nozzles which they control.
For example the cannode on the left in Fig. 6 controls, the
leftmost Prostop-E valves on the boom, the cannode on
the right controls the rightmost valves on the boom and
the center cannode controls the Prostop-E valves in the
center section of the boom.
15. Install the two black M12 connectors, marked “CANBUS”
and “POWER”, onto the corresponding ports of the first
cannode.
16. Install the appropriate cannode extension cable, if
needed, and repeat step for each additional cannode.
17. Run the M12 cables to the first two segments of the
ProStop-E valves. See this manual's Cannode and
ProStop-E Wiring section for further information. Repeat
for any additional cannodes.
18. Connect the ISOBUS Terminator Cable (2520-0252) (Fig.8)
into the mating connector on the last Cannode Tap Cable
(2520-0251) (Fig 4).
19. Perform the Pre-Application System Review located in
this manual.
Figure 5: Input/Output Harness (2520-0250)
2
1
3
5
4
Figure 6: Cannodes (CN32-0001)
Figure 7: Cannode Identifier And Password
Figure 8: ISOBUS Terminator Cable (2520-0252)
Example:
Identifier: 0001B6
Password: 300631