![background image](http://html1.mh-extra.com/html/pentair/mastertemp-mt200hd/mastertemp-mt200hd_installation-and-user-manual_1525208004.webp)
MASTERTEMP
™
Pool and Spa Heater Installation and User’s Guide P/N 475106 Rev. D 1/2016
To identify the heater, see the data rating plate on the inner front panel of the heater. There are two designators for
each heater, one is the Model Number and the other is the Heater Identification Number (HIN).
Heater Identification Number (HIN)
The following example simplifies the identification system:
1)
MT
: MasterTemp
2)
Model Size
: (200, 300 or 400) : Input rating (Gross BTU/hr)
3)
Construction
: (HD = Heavy Duty Model)
4)
Fuel Type
: (LP = Propane gas or NA = Natural gas)
MT
300
HD
MT = MASTERTEMP
MODEL SIZE = BTU/hr GROSS INPUT
H. I. N.
HEATER IDENTIFICATION NUMBER
ID DESIGNATOR FOR PENTAIR POOL AND SPA MASTERTEMP™ HEATERS
Example:
1
2
3
4
FUEL TYPE =
NA = NATURAL GAS
LP = PROPANE GAS
200 (200 [
BTU/hr
), 300 (300 [
BTU/hr
) or 400 (400 [
BTU/hr
)
HD = HEAVY DUTY MODEL
N
Heater Identification Information (HIN)
Heater Data Rating Plate Location
The heater data rating plate is located on the inner front panel of the heater. To access the data rating plate, unbolt and
remove the side door access panel as shown below.
Heater Data Rating Plate
Door
Access
Panel
Top Panel
Remove this Door
Access Panel to access
the DATA RATING PLATE
| Heater Identification Information
iii
0087
1
3
12
THIS HEATER IS EQUIPPED TO BURN
OUTPUT
ALTITUDE
MINIMUM CLEARANCE FROM COMBUSTIBLE
CONSTRUCTED 15 CM REAR, 15 CM TOP
DO NOT INSTALL THIS HEATER UNDER AN OVERHANG
LESS THAN 1 METER FROM THE TOP. THE AREA UNDER
THE OVERHANG MUST BE OPEN ON THREE (3) SIDES.
APPROVED FOR INDOOR AND OUTDOOR INSTALLATIONS ELECTRICAL COMPLIANCE: IN ACCORDANCE
WITH LOCAL ELECTRICAL CODES.
THIS APPLIANCE MUST BE INSTALLED IN ACCORDANCE WITH THE EUROPEAN STANDARD INSTALLATION
CODES, AND WITH THE REQUIREMENTS OF THE AUTHORITY HAVING JURISDICTION.
REFER TO THE OPERATING INSTRUCTIONS FOR
APPROVED WATER TREATMENT.
TYPE G23
G20:
G31:
TEST POINT PRESSURE
MAX. WORKING PRESSURE
mbar
mbar
mbar
3.45 mbar
ELECTRICAL RATINGS:
VOLTS:
HERTZ:
AMPS:
12 A
APPLIANCE CATEGORY
COUNTRY OF DESTINATION
YEAR OF MANUFACTURE
MODEL NO.
SERIAL NO.
DESIGN AND MANFACTURED BY PENTAIR WATER POOL AND SPA, INC.
INPUT RATE
ORIFICE SIZE
MASTERTEMP
™
POOL HEATER
GAS
kW
mm
2000 m
kW
Label P/N
GB, BE, DE, FR
Hz
V
GAS SUPPLY PRESSURE:
G25:
mbar,