2
The installation of a basin system
is a specialized skill, which
requires individuals with the basic
understanding of excavating, pipe
fitting, and electrical wiring.
These instructions are meant only to
be an installation guide; therefore,
unusual installation conditions not
covered in these instructions require
experienced personnel capable
of using reasonable engineering
principles for the installation and
operation of the system.
Excavation location shall be
made according to local codes
and regulations. Check with
local utility companies for
the location of underground
utilities prior to excavation.
Care should be taken to avoid
buried utility lines, piping, and
other buried structures and
foundations. Failure to follow
these instructions may result
in serious personal injury or
death.
Excavation for Basin Systems:
Effect appropriate excavation
based on size of the basin, desired
entrance point of the influent line,
and entrance of power connection.
Thank you for purchasing your
Low Pressure Sewer Basin System.
Before Installation:
This manual contains important
information for the safe use of
this product. Read this manual
completely and follow the
instructions carefully. Reasonable
care and safe methods relating
to the installation and operation
of this product should be
practiced. Check local codes and
requirements before installation.
Risk of electrical shock or
electrocution. May result
in serious injury or death or
fire hazard. Installer must
disconnect all electrical sources
prior to installation. Only
qualified personnel may install
this system. NFPA 70/National
Electric Code (NEC) or local
codes must be followed. System
must be properly grounded
according to NEC.
Biohazard risk. Once the
wastewater source has been
connected to system, biohazard
risk exists. Installer(s) and/
or service personnel must use
proper Personal Protective
Equipment and follow handling
procedures per OSHA 29 CFR
1910.1030 when handling
equipment after wastewater
source has been connected to
the system.
Risk of fire or explosion. Do not
smoke or use open flames in or
around this system. This system is
not intended for use in hazardous
locations per NFPA 70 National
Electric Code. Consult factory
for optional equipment rated for
this use.
Cutting risk. Risk of serious
cutting or amputation exists.
Disconnect all power sources
prior to servicing pump or
grinding mechanism. Pump may
start without warning. Grinding
mechanism is extremely sharp.
Use caution when handling
grinder mechanism.
Hydromatic does not recommend
basins with base/bottom diameters
greater than 30" when installing
a simplex Positive Displacement
pump (HPD200) system. When
operational conditions require a
basin with base/bottom diameter
of greater than 30" it is necessary
to perform a sludge pump-out
on the basin at least once per
year to prevent any septic/odor
conditions.
DO NOT THROW AWAY OR
LOSE THIS MANUAL. Keep it
in a safe place so that you may refer
to it often for the continued safe
operation of the product.
CALIFORNIA PROPOSITION
65 WARNING:
This product and
related accessories contain
chemicals known to the State of
California to cause cancer, birth
defects or other reproductive
harm.
General
Information
Installation Skill
Requirements
Excavation
Instructions