4
Note: Refer to page 3 where (parts index number) is shown
EasyTouch/IntelliTouch Control System Upgrade Kits Installation Guide
Removing the Existing Outdoor Control Panel
The following upgrade installation instructions are for
EasyTouch
®
PL4/PSL4, EasyTouch or IntelliTouch
Control Systems
using the 2012 or later (square low voltage circuit breakers configuration on bezel) Load
Center or Power Center.
1. TURN OFF POWER TO ALL POOL AND SPA EQUIPMENT BEFORE STARTING.
CAUTION! DO NOT PLUG IN OR UNPLUG ANY SYSTEM COMPONENTS WITH THE
POWER ON. THIS MAY DAMAGE THE SYSTEM COMPONENTS.
2. Unlatch the front door latch. Open the door of the Load Center or Power Center.
3. Remove the two screws securing the High Voltage Cover Panel. Remove the panel and set
aside.
4. Loosen the two retaining screws securing the existing control panel. Fold down the panel to
access the circuit board low voltage connections and transformer connector.
Continue to next page
WARNING!
RISK OF ELECTRICAL SHOCK. BEFORE REMOVING THE HIGH VOLTAGE
COVER PANEL FROM THE ENCLOSURE
SWITCH OFF THE
MAIN POWER AT THE HOME AT THE MAIN CIRCUIT BREAKER BOX.
Figure 2. Load Center or Power Center (2012 or later)
Retaining screw
Retaining screw
Bezel screw
Bezel screw
High Voltage
Cover Panel
Retaining screws
(for High Voltage Cover
Panel)
Front
door
Three Tabs/Slots
