P/N 520050
20
Rev. F 3-26-04
CP-100 OPTIONAL INDOOR CONTROL PANEL
If the system has an
Indoor Controller
, verify that there is a
TEMPERATURE Display
and check that the
EQUIPMENT STATUS INDICATORS
are functioning when the
Push-buttons
are activated.
If there is no status display, check the connections at each end of the communication cables very carefully. If necessary,
crimp new modular connectors to the cables.
If the
TEMPERATURE Display
indicates three dashes (- - -) or a very high temperature (400 degrees or more),
check the connections to the Temperature Sensor.
At the Indoor Controller, press appropriate
Push-button(s)
so that none of the
EQUIPMENT STATUS
INDICATORS
are illuminated.
At the Indoor Controller, press
Push-button #S
to turn the spa on.
Verify that the Valve Actuators have rotated to spa circulation, the filter pump has been activated and the heater has
fired.
Press Push-buttons
#1, #2
and
#3
, and check that appropriate equipment is being activated.
A set of adhesive labels is provided for custom identification of equipment.
Use a pair of fine-tip tweezers to adhere the appropriate label(s) below the
Push-button(s)
on the Indoor Controller.
Calibration of the
TEMPERATURE Display
has been preset at the factory. However, fine adjustment can be
accomplished if necessary.
Insert a small flat-blade screwdriver through the
ADJUST hole
which is located behind the right door of the Indoor
Controller, and rotate the Adjustment Screw accordingly.
The system is now ready to be operated as desired.