Page 7 of 10
NOTE
Head Rebuilding should be performed in
a clean work area. Dust or dirt on O-rings
or other parts can scratch inner surfaces,
with subsequent leakage.
Head Disassembly
CAUTION
During the next step, one or both Port
Retainer halves may fall out.
1. Using a small screwdriver or similar tool remove the
Plug Seal. However do not damage the sealing surface
in any way as it may lead to leakage.
4. Rotate sealing plate relative to bearing plate and
separate the two.
Removal of the Plug Seal
2. Remove circlip from its groove in the Permeate port.
Take care not to scratch the hard-anodized surface of
the bearing plate.
Separate the Sealing plate and the Bearing plate
5. Push Feed/Concentrate Port further into the
bearing plate, remove the two Port Retainer
segments, then pull Feed/Concentrate Port out of
the Bearing Plate.
Removal of the Circlip
3. Pull permeate port out of the Head Assembly.
Removal of F/C Port from the Bearing Plate
6. Check all head components as shown in the picture
Head Component Identification - 40E100 on page 8.
Removal of the Permeate port from
the End Plug Assembly
Distributed by Applied Membranes, Inc. | www.appliedmembranes.com | (760) 727-3711 | USA
