Rev. C 7-29-05
25
P/N 840259
SECTION IX.
Sychronization of S
Am
®
/S
AL
®
and FIBERworks
®
(Wiring Diagrams)
PG2000 & S
Am or SAL Synchronization Switch
Wiring Schematic
Service
Panel
Black
Black
Red
Green
White
Line
Neutral
Ground
PG2000
#840242
3 Toggle Switches
or
3 Compool/IntelliTouch Relays
SAm/
SAL
Yel
NOTE
There may be slight color variations between the
S
Am
®
/SAL
®
and PG2000 depending on the application. These variations are caused
by differences in initial light intensity and attenuation of the water and/or reflective surfaces (i.e. pool wall coloring).
In order for instructions to work you must have P/N 840242 – 7 Color, Electronic Synchronized PG2000
(all other part numbers must use visual synchronization method).
A. Compool
®
Programming
1. If you use a Compool system, you can automate the process by programming two identical start and run
times for the
S
Am
®
or
SAL
®
auxiliary channel(s). (i.e., Program 1 -
ON
: 8:00 PM,
Run Time
: 4 Hours;
Program 2 -
ON
: 8:00 PM,
Run Time
: 4 Hours.) The two channels for the PG2000 should be
programmed to come on only one time. (i.e., Program 1 -
ON
: 8:00 PM,
Run Time
: 4 Hours).
Of course, you could also program
S
Am
®
,
SAL
®
or
FIBER
works
®
to run alone or even out of
synchronization if desired.
B. IntelliTouch
®
Programming
If you use an IntelliTouch system, you can automate the process by identifying the applicable circuit as a
S
Am
®
,
SAL
®
or
Color Wheel
(go to MENU/SETUP/ADVANCED/CIRCUIT FUNCTIONS).
Once this is done, you will
have the option in the Programming to set these circuits to "
SMART START
". All circuits set to "
SMART
START
" and programmed to come on at the same time will automatically synchronize.
(continued on next page)
