P/N 840259
14
Rev. C 7-29-05
AmerGlow Lens Assembly
1.
Remove 1 in. of the jacket with the stripper.
3.
Add seal nut and tighten.
5.
Angle hotknife 15 degrees.
7.
Slowly screw on lens cap.
2.
Add tape, spacer ( if needed), compression nut and grommet.
4.
Screw on cutting shield.
6.
Fill Standard Lens reservoir with gel. (No gel required in
Wide Angle Lens.)
Tools and Material Required:
√√√√√
Cable Stripper
√√√√√
Crescent Wrench
√√√√√
Hot Knife
√√√√√
Cutting Shield
√√√√√
Lens Tightening Tool
√√√√√
Electrical Tape
√√√√√
OptiFusion Gel (Standard Lens)
1/16 IN. OF JACKET SHOWING
CHECK FOR AIR BUBBLES IN GEL
(STANDARD LENS)
GROMMET FLUSH
WITH FRONT FACE
