Rev. C 7-29-05
15
P/N 840259
1/16"
1"
Spacer with O-ring - use
with Invisible Gunite and
Vinyl Liner Lens Housing
Seal Nut
Lens Retaining
Nut
Standard
Lens
Lens
O-ring
Lens
O-ring
Wide
Angle
Lens
Seal Nut
O-ring
Grommet - select
proper size for cable
Compression Nut
FIBERworks Lens Housing
(Invisible Gunite shown)
(4. e.) • Hold the seal nut stationary with your hand and rotate the compression nut using a crescent wrench.
•
If you use channel locks to hold the seal nut, be careful not to damage the O-ring.
•
Tighten the compression nut until the grommet is flush with the front surface of the seal nut (for smaller
cables) or there is only one thread left showing on the compression nut (for larger cables).
•
Pull on the completed assembly to be sure cable does not move.
8. Cable in fitting, use a spacer if needed.
9. Hand-tighten the retainer nut.
INVISIBLE GUNITE
LENS HOUSING
VINYL LINER
LENS HOUSING
BEFORE OR AFTER
FACE PLATE
AmerGlow Lens Assembly Installation Steps, continued.
Figure 5.
