PENSOTTI PCC 34-H, Instruction Manual

Page: 62 / 72

INSTALLATION INSTRUCTIONS
59
Diverter valve (see fig. 1)
Replacing the motor
Unscrew the fixing screws securing the transparent cover
of the diverter valve and remove the cover;
Unscrew the two motor fixing screws and disconnect the
wires;
Replace the motor and re-assemble the components
following the above procedure in reverse order;
Replace the motor and re-assemble the components
following the above procedure in reverse order;
Replacing the diverter valve
Close the shut-off valves and drain the central heating
circuit of the boiler;
Disconnect the joints securing the valve to the pipes;
Replace the valve body and re-assemble the components
following the above procedure in reverse order;
Switch on the electricity, water and gas supplies and fill the
system with water. Check for any leaks from the joints and
bleed off any air from the circuit. Restart the boiler.
Modulating circuit board (see fig. 2-3)
Open the control panel
(see 6.4
“Accessing the boiler”);
Disconnect all the connectors, remove the
regulating knobs, unscrew the four fixing screws and
remove the modulation circuit board;
Replace the circuit board and re-assemble the
components following the above procedure in reverse
order;
Switch on the electricity, water and gas supplies
and regulate the boiler (see
5.3 “Gas data”)
;
Replacement modulating circuit boards must be
programed to the correct parameters before starting
the appliance. Refer to section 5.1 parameters table.
Electric fan circuit board (see figs. 2-3)
Open the control panel (see 6.4
“Accessing the
boiler”)
;
Disconnect the two connectors from the circuit board,
unscrew the two fixing screws and remove the board;
Replace the circuit board and re-assemble the
components following the above procedure in reverse
order;
Switch on the electricity, water and gas supplies.
electric fan circuit board
modulation circuit board
Fig. 2
electric fan circuit board
modulation circuit board
Fig. 3
diverter valve motor
Fig. 1