#500995-001 -
Product Manual: #LG5 Series Manhole Guard Retrieval System
- Revision 06 - Date: 01-09-2018
Page 22
Installation of the Hoist to Adapter (Part 2):
Note: The #LGL-B accessory will accept any Pelsue PH Series hoist that is outfitted with a standard quick-release
bracket
a.
Before installing the hoist, ensure that the LG5 system is assembled correctly.
b.
First slide the open slot of the hoist mount onto the welded bar on the hoist adapter (Fig. #8.1c).
c.
Then line up the holes on the hoist mount and the hoist adapter and insert the provided hitch pin (Fig. #8.1d).
d.
Enough hoist cable can now be payed out so that the hoist line can be reeled over the pulley and carabiner that
is included with the LG5 system ( Fig. #5.1a ). Ensure that the pulley and carabiner are properly fastened to an
overhead anchor point and operate the system within the limits of the LG5 system & the hoist.
Note: If required, a secondary Fall arrest System can be attached to the second swivel eye at the apex in correspond-
ence to the manufacture’s instructions for that device.
! CAUTION !
Pelsue can only verify compliance & compatibility with Pelsue PH Series Hoists. Devices other than Pelsue PH Series
Hoists must be checked for compatibility.
Figure #8.1c
Hoist Installation Step 01
Figure #8.1d
Hoist Installation Step 02
Figure #8.1e
Hoist Installation Step 03
8.1 - LGL-B Mounting Bracket (continued)