pellenc Rasion Easy, User Manual, Page: 70 / 254

W
ARNING!
Always disconnect the lawn mower from the battery before working on the cutting blades.
TROUBLESHOOTING AND TOOL PROTECTION
Problem
Check
Probable cause
Possible action
The lawn mower is not cutting grass
Grass is too high
Increase the cutting height
Cutter housing clogged
-
Turn of
f the battery
.
-
Clean the inside of the housing
-
Restart the battery
Turning speed of the blades is too low
Increase the turning speed of the blades
Collecting bin full
Empty the collecting bin
Damaged or blunt blades
Sharpen or replace the blades
The lawn mower stops
The diodes are lit with a flashing error code
The lawn mower has overheated
-
Allow the lawn mower to cool down
-
Reduce the speed of the lawn mower
-
Increase the cutting height of the lawn mower
Density sensor clogged
-
Switch to manual mode or
-
Switch of
f the battery / Clean the optical sensor with
water and a wet cloth /
Turn the battery back on
The display is not powered
The battery is discharged
Recharge the battery using the battery charger
.
The battery beeps then goes of
f
1 long beep + 1 short beep
Surge alarm
Grass too high or too dense
1 long beep + 2 short beep
Lawn mower temperature alarm
Allow the lawn mower to cool down
1 long beep + 3 short beep
Over voltage or under voltage alarm
Battery flat or damaged
1 long beep + 4 short beep
Blockage safety alarm
Turn of
f the battery / unblock the blades and/or clean the
housing / Restart the battery
1 long beep + 5 short beep
Motor alarm
Contact your approved distributor
.
1 long beep + 6 short beep
Trigger alarm
Damaged handlebar cable Contact your approved distributor
.
32