pellenc AIRION 3, Operating Instructions Manual

Page: 26 / 40

BLOWER AIRION 3
57 - 147010-C
6. SERVICE
6.1. MAINTENANCE ADVICE
Caution
Always disconnect the tool battery before starting tool maintenance.
• Use products recommended by PELLENC.
• In the event of any problem, consult an authorised PELLENC distributor.
6.2. TOOL MAINTENANCE TABLE
At each
start-up
After each use If necessary
Every year
or when
necessary
Cleaning the tool X
Visual inspection of the tool X
Check for clogging of the grid; clean if necessary X X
Check the rotor:
• clean if necessary
• replace if necessary (by an authorised PEL-
LENC distributor).
X
Checking the capacity of the battery X
Replace the safety labels X
Have the tool inspected by an approved Pellenc
distributor.
X
Important
Have your blower overhauled every 400 hours or at least once a year. Always make sure the tool is clean
and its battery is charged before storing it.
6.3. CLEANING
Warning
Never use solvents (trichloroethylene, white spirit, petrol, etc.) to clean the tool.
• Keep your tool clean by wiping it regularly with a soft, damp cloth.
• FINISH LIST
Using an air compressor (10 bars maximum), blow on the tool, the grille and the rotor on a regular basis to limit
clogging.
Check that the whole air duct (from the intake to the outlet) is not obstructed.
26