CHARGING STATION PELLENC CHARGING STATION
56_136922-B
4. Position the support brackets so that the buttons and
the charging connector of the tablet remain acces-
sible.
4. Lightly loosen the nuts holding one of the side brack-
ets.
4. Carefully insert the tablet between brackets and
door (making sure you do not scratch the tablet's
screen with the upper studs).
4. Put the side bracket back against the tablet and
tighten its nuts.
4. Retighten the nuts.
4. Reposition the upper bracket against the tablet and
secure it with screws and washers.
4. Tighten the 4 pressure screws (not too tightly).
4. Connect the tablet's charging cable to its connector.
4.7. FORCED POWER SWITCH
The switch (11) located on the electrical box makes it
possible to switch the Charging station into forced oper-
ation: the chargers are then permanently powered.
This mode allows the chargers to be used to recharge
the batteries if the tablet is not operating correctly.
In normal use of the PELLENC CHARGING STATION
and most of the time, this switch is in the Off position ("O"
pressed).
1. To activate forced operation, turn the switch to the
"I" position ("I" pressed).
4.8. FIRST STARTUP
1. Check that the switch (11) is not in the forced over-
ride on position.
2. Check that the charging station is connected to the
circuit-breaker.
3. Switch the charging station on.
4. Turn the tablet on by pressing its start button for 5
seconds.
Note
The tablet may take several minutes to start up.
23
