51
Note:
1. When the input is not connected, i. e. at open circuit, the
Figure "OL" will
be displayed for the overrange
indication.
2. The circuit to be tested must be in power off status during the
continuity
check.
6.10 frequency measurements:
ATTENTION!
Do not perform measurements on circuits with voltages above
250V DC / AC rms. Exceeding this voltage value, the risk of
serious injury exists due to electric shock and / or the risk of
damage to the device.
1. Turn the Function / Range switch (2) in the required frequency
measuring position.
2. Connect red test lead to the V/
/CAP/Hz/Temp. - input, black
lead to the COM input.
3. Connect test leads across the circuit to be measured or the
component to be measured and read the frequency in the
LCD display.
4. For accurate frequency measurements a measuring line is
recommended with BNC connectors.
