66
Cyclone for ARM devices User Manual
Cyclone for ARM
®
devices
8.7
Using ConfigureIP.exe To Configure The Cyclone for ARM devices
Before the Cyclone for ARM devices is ready to communicate over an
Ethernet network, it will need to be configured with the relevant network
parameters. The application that provides this capability is the Cyclone
Configuration Utility (IPSetup.exe), and is provided as part of the standard
Cyclone for ARM devices software distribution.
In order to update the network parameters, perform the following steps:
1. Connect a Cyclone for ARM devices to the PC via a serial or a USB
cable, and make sure that it is powered before launching the Cyclone
Configuration Utility. The Cyclone for ARM devices Configuration Util-
ity starts up with the following screen:
Figure 8-2: Cyclone IP Setup Utility - Initial Screen
2. Assuming that the Cyclone for ARM devices is connected to the
COM1 serial port of the PC, switch from “Ethernet Port” to “Serial
Port”, at which point the second drop-down box will display COM1.
Click “Open” to get a dialog box similar to the following:
