PDI-P15LCDB User Manual
Document Number: PD196-096 Rev 2
- 7 -
Arm Installation
LOCATION GUIDELINES
The PDI-P15LCDB-ARM TV is intended for entertainment purposes and should be installed in a
non-hazardous area in accordance with the National Electrical Code (NEC), ANSI/NFPA 70.
The PDI-P15LCDB-ARM TV is designed to be mounted and supported on either a PDI 405 or
500 series support arm. Select a location that is near an AC wall outlet and that does not expose
the TV to bright room lights or sunlight if possible.
CABLE SYSTEM GROUNDING
The coax cable system connected to the PDI-P15LCDB-ARM TV should be grounded in
accordance with the National Electrical Code, ANSI/NFPA 70. The code provides guidelines for
proper grounding and, in particular, specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of the cable entry as practical.
SUPPORT ARM
The PDI-P15LCDB-ARM is designed to mount to either a 405 or 500 series support arm that is
pre-strung with an LCD power cable and RF coax cable. Computer display functionality requires
an arm pre-strung with a compatible VGA computer cable.
Attach Monitor to Arm
a. Fasten mounting plate “A” to mounting
channel “B” using (4) #10 flat washers
and (4) 10-32 nylock hex nuts
provided.
b. Connect the Antenna cable to the
“ANT.”
c. Connect the power cable to “DC 12V”.
d. For computer operation connect
computer VGA cable to “PC/DTV IN”
and audio cable to “PC AUDIO IN”.
Cable Cover
a. Position cable cover “C” into mounting
channel “B”.
b. Attach cable cover with (4) #8x32
screws.
A
B
C
B