3
This Operating Manual covers information on safety and cautions. Please read the
relevant information carefully and observe all the
Warnings
and
Notes
strictly.
Warning
Except where noted, the descriptions and instructions in this Operating Manual apply
to all
Model UT61A/UT61B/UT61C/UT61D/UT61E
.
Unpacking Inspection
Open the package case and take out the Meter. Check the following items carefully
to see any missing or damaged part:
Description
Operating Manual
Test Lead
Point Contact K type Temperature Probe (UT61B and UT61C only)
UT61 Multi-Purpose Socket
9V Battery (NEDA1604, 6F22 or 0006P) (installed inside the Meter)
RS232C Interface Cable(except UT61A)
USB Interface Cable (Optional at extra cost) (except UT61A)
Installation Guide & Computer Interface Software (CD-ROM) (Come
along with the RS232C or USB Interface Cable) (except UT61A)
Item
1
2
3
4
5
6
7
8
Qty
1 piece
1 pair
1 piece
1 piece
1 piece
1 piece
1 piece
1 piece
In the event you find any missing or damage, please contact your dealer immediately.
Safety Information
This Meter complies with the standards IEC61010: in pollution degree 2, overvoltage
category (CAT. III 1000V, CAT. IV 600V) and double insulation.
CAT III: Distribution level, fixed installation, with smaller transient overvoltages than
CAT. IV.
CAT IV: Primary supply level, overhead lines, cable systems etc.
Use the Meter only as specified in this operating manual, otherwise the protection
provided by the Meter may be impaired.
In this manual, a
Warning
identifies conditions and actions that pose hazards to the
user, or may damage the Meter or the equipment under test.
A
Note
identifies the information that user should pay attention on.
International electrical symbols used on the Meter and in this Operating Manual are
explained on page9.
